Since June 2009, I worked as a software developer at DEIF Wind Power Technology, DEIF A / S. In an international team I work with development of wind turbine controllers, with main focus on integration of the generated software modules in an existing code base. At the same time, I work with the development of test systems for wind turbine control systems and auto generation of load calculation and verification modules.
As part of my work I participate in onsite support and training for Chinese customers and colleagues. On a daily basis I assist Indian and Chinese customers and colleagues by remote support if any problems should occur e.g. setup or configuration of devices, fieldbuses etc.

Courses/Certifications:

• L-AUS
• Fall-arrest
• First-aid

From January 2009 to May 2009 I worked as a software developer at Hybrid Tech ApS until the company was purchased by DEIF Wind Power Technology, DEIF A / S. At Hybrid Tech ApS I worked on a web solution for remote reading of utility meters, as well as various consulting tasks and customer visits with focus on Hardware-in-the-loop (HIL) simulation,PLC IEC 61131-3

From October 2007 to December 2008 worked as a systems developer at inCaptiva A / S, which develops intelligent web solutions. My primary task was to develop the content management system ICMS / iPortal implemented in ASP.NET (C #) in the development environment Visual Studio 2005 Team System.

Courses/Certifications:

• MCTS
• MCP
• Health and safety representative
• First-aid

From May 2006 to September 2007 I worked as a software developer for Swarco Technology ApS in Odense, developing traffic controllers. I was part of a development team with four other engineers, where I used the following technologies: C ++, embedded Linux, CGI, Ajax and subversion as a natural part of my work.